Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Setting the rotating direction
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the rotation direction
switch
until the product has come to
[
5 ]
a standstill .
Change the direction of rotation by pressing
o
the rotation direction switch towards the left or
right (fig . G) .
When the rotation direction switch is in the
o
middle position, the on/off switch
locked .
˜ Torque control
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded .
The torque can be adjusted by turning the
o
torque sleeve
(fig . H) .
[
3 ]
Small screws or soft materials: Select a low
o
level .
Large screws, hard materials or removing
o
screws: Select a high level .
For drilling operation: Turn the torque sleeve
o
to the position .
˜ Switching on and off
NOTE
The on/off switch
6 ]
[
Switching on: Press and hold the on/off
o
switch .
Regulate the speed as required (see "Speed
control") (fig . I) .
Switching off: Release the on/off switch .
o
˜ Speed control
By using the on/off switch
o
progressively control the speed:
18 GB/IE/NI
is
6 ]
[
cannot be locked .
, you can
6 ]
[
Pressure
Gentle pressure
Greater pressure
˜ LED work light
This product is equipped with a LED work light
to illuminate the immediate working area to
improve visibility in poorly lit areas .
The LED work light lights up automatically as
o
soon as the product is switched on .
NOTE
The LED work light stays on for an
u
additional approx . 10 seconds after
switching off the product .
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement . Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises .
Before operating the product, check whether
o
the accessory tool is correctly positioned, i .e .
centred in the chuck
Screw bits are labelled according to their
o
dimensions and their shape . If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free
play .
˜ Working instructions
Torque
Smaller screws/bits can be damaged if you
o
set the torque or rotational speed too high .
Speed
Lower speed
Higher speed
11 ]
[
.
1 ]
[
Advertenties
Hoofdstukken
Inhoudsopgave
