Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Attaching/removing the
accessory tool
m
CAUTION! RISK OF INJURY!
Accessory tools can be sharp and
may become hot during use . Always
wear protective gloves when handling
accessory tools!
m
WARNING!
Always switch the product off, remove
the battery pack
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation .
m
CAUTION! RISK OF INJURY!
After the product has been switched off, the
u
accessory tool continues moving for some
time . Do not touch the accessory tool and
do not attempt to brake it .
This product is equipped with an automatic
spindle lock to open or close the chuck
the chuck sleeve
.
[
2 ]
1 . Open the chuck: Turn the chuck sleeve in a
counter-clockwise direction (Fig . E) .
2 . Insert a suitable accessory tool into the chuck
as deep as required .
3 . Close the chuck: Hold the accessory tool in
position . Turn the chuck sleeve in a clockwise
direction .
and let the
10 ]
[
with
1 ]
[
NOTES
This product is equipped with a Röhm drill
u
chuck with an anti-lock function .
If you attempt to open the fully opened
u
chuck further, the anti-lock function will be
activated to protect the chuck .
When the anti-lock function is activated,
u
the chuck cannot be closed by turning the
chuck sleeve in a clockwise direction . A
ratcheting sound will be produced when
you attempt to close the chuck .
Deactivating the chuck's anti-lock function:
u
Turn the chuck sleeve in a clockwise
direction by a certain extent . Then, turn
the chuck sleeve suddenly and quickly in a
counter-clockwise direction .
Repeat this action if the anti-lock function
is still active . When the anti-lock function is
deactivated, you should be able to close
the chuck without ratcheting sounds .
˜ Gear selection
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the gear selector
until the product has come to a
standstill .
Change the gear by sliding the gear selector
o
forwards or backwards (fig . F) .
1
gear:
st
Suitable for:
Speed:
Torque:
2
gear:
nd
Suitable for:
Speed:
Torque:
[
4 ]
Screwing
Low
High
Drilling
High
Low
GB/IE/NI
17
Advertenties
Hoofdstukken
Inhoudsopgave
