Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
There is too much frost and
ice.
Water flows inside the refrig‐
erator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap‐
pliance is too low and the
ambient temperature is
too high.
Temperature is set incor‐
rectly.
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
Progress 25
Solution
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Refer to "Closing the door".
Set a higher temperature. Re‐
fer to "Operation".
Set a higher temperature. Re‐
fer to "Operation"
Refer to "Operation" .
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.
Defrost the appliance.
Open the door only if necessa‐
ry.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
