Advertenties
Beschikbare talen
Beschikbare talen
Deleting both limit positions
Put the transmitter into master mode.
Select the tubular drive by pressing the
firms.
All the following settings will then only be executed for this device.
5s
Performing the programming run on B-Tronic
radio receivers
Feedback is disabled and it is not possible to program the in-
termediate positions until the programming run has been
performed.
Put the transmitter into master mode.
Select the receiver by pressing the
firms.
All the following settings will then only be executed for this device.
58 - en
button until the tubular drive con-
Open/close the shading solution to a point
between the limit positions.
Press the programming button and, within 1
second, press the STOP button at the same time
and hold the two buttons down for 5 seconds.
▻ The receiver confirms.
► The limit positions are now deleted.
button until the required receiver con-
Open to the desired upper limit position.
Press the programming button and, within 1
second, also press the UP button and hold the two
buttons down.
▻ The receiver confirms.
Then close to the desired lower limit position.
Advertenties
