Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Programming transmitter
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
3s
Programming more transmitters
The receiver mode must always be set appropriately for the
receiver. Roller shutter is the factory setting.
Programming more B-Tronic transmitters in the B-
Tronic receiver
Put the receiver into programming mode.
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
Putting the B-Tronic receiver into programming mode
• Using a programmed B-Tronic transmitter
Put the transmitter into master mode.
Select the receiver by pressing the
firms.
All the following settings will then only be executed for this device.
50 - en
Press the programming button of the transmitter
for 3 seconds whilst in programming mode.
▻ The receiver confirms.
► Programming is now complete.
button until the desired receiver con-
Advertenties
Hoofdstukken
Inhoudsopgave
