Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USING THE REMOTE CONTROL
The laser can be operated with the help of the remote control. The
effec�ve range of the remote control is 328 � (100m). Press On/Off bu�on
both on the device (№7 pic.2) and remote (№9 pic.3) to start opera�on
from the remote control.
POWER SUPPLY FOR ROTATING LASER:
The rota�ng laser is supplied with rechargeable ba�eries and a charger
(AC/DC converter).
NOTE: Do not use alkaline batteries and charger at the same time, as they may
damage the damage the laser.
1. Charge the rechargeable ba�eries if the power indicator blinks (№13 pic.2).
2. Connect the charger to an electrical outlet.
3. Insert the connector into the pin socket (№5 pic.1).
4. Indicator on the charger lights orange when charging. If the rechargeable
ba�ery is fully charged, indicator lights green.
5. It's possible to remove ba�eries from the tool. Unscrew screws in the
ba�ery compartment cover (№3 рic.1).
IMPORTANT: You can operate with the tool while it is charging.
Detector
1. Press the fixator on the ba�ery compartment and remove the ba�ery
compartment cover.
2. Remove ba�ery 9V.
3. Insert new ba�ery 9V. Obsurve the polarity. Close the ba�ery
compartment cover.
Remote control
Ba�ery compartment is located on the back side of the remote control.
1. Remove the ba�ery compartment cover.
2. Remove ba�eries.
3. Insert ba�eries type "AAA". Obsurve the polarity. Close the ba�ery
compartment cover.
INSTALLING THE LASER LEVEL
Place the tool on the stable support in horizontal or ver�cal posi�on.
The tool can compensate a �lt automa�cally up to ± 5°.
NOTE: to project vertical plane in automatic mode, place the tool with
keypad up.
16
Advertenties
Inhoudsopgave
