Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation guide at the
seaside
LET OP
!
- Air conditioners should not be installed in
areas where corrosive gases, such as acid
or alkaline gas, are produced.
- Do not install the product where it could be
exposed to sea wind (salty wind) directly. It
can result corrosion on the product.
Corrosion, particularly on the condenser
and evaporator fins, could cause product
malfunction or inefficient performance.
- If outdoor unit is installed close to the
seaside, it should avoid direct exposure to
the sea wind.
Otherwise it needs additional anticorrosion
treatment on the heat exchanger.
Selecting the location
(Outdoor Unit)
If the outdoor unit is to be installed close to
the seaside, then direct exposure to the sea
wind should be avoided.
Install the outdoor unit on the opposite side of
the sea wind direction.
Sea wind
Sea wind
In case of installing the outdoor unit on the
sea side, setup a windbreak to prevent sea
wind.
Windbreak
Sea wind
- It should be strong enough like concrete to
prevent the sea wind from the sea.
- The height and width should be more than
150% of the outdoor unit.
- Keep more than 70 cm of space between
outdoor unit and the windbreak for easy air
flow.
Select a well-drained place.
- If you can't meet above guide line in the
seaside installation, please contact LG
Electronics for the additional
anticorrosion treatment.
- Periodic ( more than once/year ) cleaning
of the dust or salt particles stuck on the
heat exchanger by using water
* Do not use seawater when you clean up
the heat exchanger.
INSTALLATIE
31
Advertenties
Inhoudsopgave
