Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USER MANUAL
SAFETY FUNCTIONS
The machine is equipped with the following safety functions.
EMERGENCY PUSH-BUTTON
It is located in an easily accessible position (12, Fig. B). It has
to be pressed in case of emergency, to stop all the machine
functions.
To reset it, turn it clockwise.
HOOD SAFETY SWITCH
It activates when the machine hood is opened: It stops all
functions.
If the machine keeps operating when the hood is open,
contact an authorised Service Center or Retailer immediately.
DRIVER'S SEAT MICROSWITCH
It is located inside the driver's seat and it does not allow the
machine drive system to operate if the operator is not seated
on the driver's seat.
16
TROUBLESHOOTING
Trouble
Check the battery connector (6, Fig. U) for
proper connection.
Check that the hood (10, Fig. C) is closed.
The machine does not
start when turning the
Check the fuse F1 in the box (9, Fig. U) for
ignition switch to "I"
integrity.
position.
Check that the optional battery charger (7,
Fig. U) is disconnected from the electrical
mains.
Check that the parking brake (6 and 7, Fig.
C) has been released.
Check that the switch (19, Fig. U) is in "I"
position.
Check that the drive pedal (5, Fig. C) is not
The machine does not
pressed while starting the machine with the
move by pressing the
ignition switch (2, Fig. B), or while the
pedal (5, Fig. C).
operator is sitting on the driver's seat. The
drive pedal (5, Fig. C) has to be pressed
only after the operator has sit on the
driver's seat and the machine has been
started.
The side brooms do
Check the fuse F6 in the box (9, Fig. U) for
not operate.
integrity.
The machine operates
only when stationary,
Charge the batteries. If the trouble
otherwise it switches
persists, replace the batteries.
off and the red warning
light (3, Fig. B) flashes.
Battery autonomy is
Install batteries having higher capacity
low.
(minimum 100 Ah C5).
NOTE
If the machine has been supplied with the
optional battery charger, the machine cannot
operate if the charger is not on board. In case
of battery charger malfunction, contact an
authorised Service Center.
For further information, refer to the Service Manual, available
at any Nilfisk-Advance Service Center.
SCRAPPING
Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove the following
materials, which must be disposed of properly according to
the law in force.
–
Batteries
–
Polyester dust filter
–
Main and side brooms
–
Electrical and electronic components (*)
–
Plastic components and hoses
(*)
Refer to the nearest Nilfisk-Advance Center especially
when scrapping electrical and electronic components.
Remedy
146 1957 000(4)03-2016
Advertenties
Hoofdstukken
Inhoudsopgave
