Programming Intermediate Positions I + Ii In Venetian Blind Operation; Checking Intermediate Position Ii (Tilt Position) - Becker Centronic VarioControl VC470-II Montage- En Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Programming intermediate positions I

+ II in Venetian blind operation

If an intermediate position II (tilt position) has been pro-

grammed, the blind will automatically travel to this position

by double-tapping DOWN in the limit position (once the run-

ning time has elapsed). If an intermediate position I has also

been programmed, the blind is tilted as soon as intermediate

position I is reached.

Application

Venetian blind operation

Intermediate position II (tilt position)

This function lets you move the Venetian blind up again from

the lower limit position until the desired intermediate posi-

tion II is reached. Both limit positions must be set before in-

termediate position II is set.

Programming intermediate position II (tilt position)

Move the blind from the lower limit position to the desired intermediate posi-

tion II.

First press and hold the STOP button and, within the next 3 seconds, press

and hold the UP button. Keep both buttons depressed until

▻ the receiver confirms.

► Intermediate position II is now saved.

Press the UP button twice within one second.

► The blind moves to intermediate position II.

30 - en

Function

Tilting

Inhoudsopgave

Advertenties

Hoofdstukken

Inhoudsopgave