Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
TROUBLESHOOTING
Trouble
The motors do not operate: no warning light turns
on
The machine does not move.
(Only for SCRUBTEC 545BL, 553BL e BOOST 5)
The warning lights (81) fl ash simultaneously.
The brush does not work, the red warning light
(81c) is on.
The recovery water vacuuming is insuffi cient.
The solution fl ow to the brush is insuffi cient.
The squeegee leaves marks on the fl oor.
NOTE
If the machine has an optional battery charger installed, the machine cannot operate if the charger is not on board. In
case of battery charger malfunction, contact an authorised Service Center.
For further information refer to the Service Manual, available at any Nilfi sk Alto Service Center.
SCRAPPING
Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
–
Batteries
–
Brushes/pads
–
Plastic hoses and components
–
Electrical and electronic components (*)
(*)
Refer to the nearest Nilfi sk Alto Center especially when scrapping electrical and electronic components.
28
All manuals and user guides at all-guides.com
USER MANUAL
The battery connector (12) is disconnected.
The batteries are completely discharged.
The machine has been turned on by using the
ignition key (80) and by keeping the switches
(83) pressed.
The brush deck motor is overloaded.
The batteries are discharged.
The recovery water tank (21) is full.
The hose (15) is disconnected from the
squeegee.
The vacuum grid (36) is clogged or the fl oat is
stuck closed.
The squeegee (25) is dirty or the squeegee
blades are worn or damaged.
The tank cover is not properly closed or the
gasket (31) is damaged.
The solution/clean water fi lter (51) is dirty.
The tank is dirty (the drain hole is clogged).
The Chemical Mixing System tank (optional)
is dirty/clogged.
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee has not been adjusted with the
handwheel (27).
SCRUBTEC 545B – 545BL – 553B – 553BL – BOOST 5
Possible Cause
Connect.
Charge the batteries.
Turn the ignition key (80) to "0", then try to
start the machine again without pressing the
switches (83).
Use a less aggressive brush suitable for the
fl oor to be cleaned or avoid working with extra
pressure function turned on.
Charge the batteries.
Empty the tank.
Connect.
Clean the grid or check the fl oat.
Clean and check the squeegee.
Close the cover or clean/replace the gasket.
Clean the fi lter.
Clean.
Clean with the drain cycle.
Remove the debris.
Replace the blades.
Adjust.
Remedy
9097054000(2)2009-06 A
Advertenties
Hoofdstukken
