Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
pressure for the adjusting nut, then the smaller of the wire spool rotating
resistance. User can adjust it according to the wire spool diameter and the
self- habit.
Notice: While adjusting the tightness of the nut, have to make sure the wire
spool is at effective fixing of the wire spool block seat and wire block seat
end, or it will damage the wire spool or the spool shaft and it will not feed the
wire steadily.
Installation of wire feeder and connection of welding stick
1.
While installing the wire spool, check previously that wire feeding roller
in the wire feeder is suitable for the contact tip in the torch and wire
diameter
2.
After the confirmation or the replacement of the wire feeding roller and
3.
contact tip, put the press roller adjusting to the machine behind. Open
the pressure roller, and remind that do not put hands on the top of the
pressure roller when it is open to avoid being hurt when it is up spring.
4.
Insert the wire starting end to the wire feeder through the wire tube,
insert
5.
the torch socket through suitable wire feeding roller groove;
6.
When the wire is led to the torch socket, press the pressure roller again,
and then restore the pressure roller adjusting rod to press the roller.
Replacement of roller
•
Open the turning plate of the machine shell. Please remove the wire first
if there is still wire on the wire feeder;
•
Rotate anti-clockwise the cover of the wire feeder to dispatch it;
•
Grab the wire feeder with hands to pull it out slightly, then install the
needed wire feeder and wire feeding roller from the shaft;
Notice: when re-install the wire roller, it must follow the shaft. Do not use
tools to hammer it, just to avoid damaging.
•
After the installation of wire roller, screw the cover clockwise tightly. Make
sure the screw thread connection is correct, to avoid damaging of the
screw thread due to the connection deviation.
ENG
53
Advertenties
Inhoudsopgave
