Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENG
Installation
Outside Connection of the Machine
Power requirement
AC single phase 230V , 50/60HZ fused with a 15 amp time delayed fuse or
circuit breaker is required.
•High voltage danger from power source! Consult a qualified electrician for
proper installation of receptacle. This welder must be grounded while in use
to protect the operator from electrical shock.
• Do not remove grounding prong or alter the plug in any way. Do not use
any adapters between the welder's power cord and the power source recep-
tacle. Make sure the POWER switch is OFF when connecting your welder's
power cord to a properly grounded 230Vac,
50/60Hz, single phase, 14 amp power source.
Extension cord
During normal use an extension cord is not necessary. It is strongly recom-
mended that an extension cord should not be used because of the voltage
drop they produce. This drop in voltage can affect the performance of the
welder. If you need to use an extension cord it must be a #12 gauge cord at
the smallest.
-Do not use an extension cord over 25 ft. in length.
48
Advertenties
Inhoudsopgave
