Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.0 Seating
6.1 Seat cushions
Seat cushions supplied by Sunrise Medical will have Velcro®
strips that correspond to patches on the seat.
WARNING!
•
You must ensure the strips are aligned prior to using the
wheelchair.
•
Other cushions used should also have Velcro® strips in a
similar position to ensure the cushion does not slip off the
seat.
NOTE: The seat cushions, supplied by Sunrise Medical all
have removable covers.
6.2 Changing seat depth on the Puma 40 Sedeo Ergo
(Fig.6.1)
• Use a 5.0 mm Allen Key, (Hex Wrench).
• Loosen the 2 screws, (A), on the bottom of the outer seat
plate, but do not take the screws out as these prevent the
shift pieces from pulling out.
• The back assembly can now be shifted backwards or
forwards to adjust the seat depth.
• Tighten the screws.
CAUTION!
When a bigger seat depth is required ensure that the cables
are lengthened before the mechanical adjustment takes place.
WARNING!
Sunrise Medical strongly recommend that you contact your
approved Sunrise medical servicing agent to carry out this
task.
Fig.6.1
A
26
Puma 40 Sedeo Ergo
6.3 Removable seat covers
The seat covers are all fully removable using zips or Velcro
Once brackets are removed seat covers can be removed. The
zip for the backrest is located on the under side of the cushion.
6.4 JAY backrests
The standard backrest assembly will allow the fitting of a JAY
backrest, which is available as an optional extra.
6.5 Headrest (Fig.6.2 - 6.3)
To fit the headrest:
Fit the location bracket to the backrest bracket, using the
screws and nuts supplied.
If required, adjust the receiver bracket in a horizontal direction.
Ensure that the bolts are fully tightened.
The headrest height is changed by pressing the spring loaded
locking mechanism and moving the headrest up or down. Let
the locking lever go. When the headrest is in position the lock
will give an audible click.
The headrest to seat depth is adjusted by loosening the hinge
bolts with a 5mm allen key and a 13mm spanner. Adjust the
position and tighten the bolts securely.
To adjust the headrest angle, loosen the screws at the
headrest upholstery, position the headrest as required and
tighten the screws securely.
WARNING!
•
If a headrest is part of the options selected for the user/
chair, never drive the chair without the headrest attached
•
Never use the chair without a headrest if a person is
transported with the chair in a vehicle.
Fig.6.2
®.
Fig.6.3
Rev.C
Advertenties
Hoofdstukken
Inhoudsopgave
