Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PANEL DUST FILTER CLEANING AND INTEGRITY CHECK
WARNING!
–
–
–
–
Wear appropriate dust mask to avoid
breathing in dust.
1.
Drive the machine on a level ground, engage the parking
brake and turn the ignition key (61) to "0".
2.
Open the battery compartment hood (18) with the handle
(41) and fasten it with the support rod (52), then disconnect
the battery connector (45).
3.
Disconnect the vacuum system motor connector (53).
4.
Release the fasteners (A, Fig. 13) and remove the vacuum
system cover (B).
5.
shaker assembly (D).
6.
7.
8.
Method "A"
surface (with the dirty side down) to remove dust and dirt.
NOTE
Take care not to damage the metal lip which extends
past the gasket.
Method "B"
Method "C"
for 15 minutes, then rinse it under a gentle stream of water
installing it back into the machine.
and non-lathering detergents.
This provides better quality cleaning but reduces the life of the
CAUTION!
or detergents to clean it, otherwise it can be
damaged.
9.
following:
(G. Fig. 14) upwards).
replaced.
USER MANUAL
A
B
A
Figure 13
E
D
C
C
F
Figure 14
1464809000 - SW4000
ENGLISH
A
A
P100600
C
G
C
P100601
27
Advertenties
Hoofdstukken
Inhoudsopgave
