Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
AFTER USING THE MACHINE
After working, before leaving the machine, perform the following procedures.
–
–
Empty the hopper (11) (see the procedure in the previous paragraph).
–
Lift the main broom with the lever (63).
–
Lift the side brooms with the lever (64).
–
Turn off the machine by turning the ignition key (61) to "0", then remove it.
–
Engage the parking brake.
–
If necessary, charge the batteries (see the procedure in Maintenance chapter).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
–
Perform the procedures shown in After Machine Use paragraph.
–
Check that the machine storage area is dry and clean.
–
Disconnect the battery connector (45).
–
Maintenance chapter).
MAINTENANCE
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.
18
USER MANUAL
SW4000 - 1464809000
Advertenties
Hoofdstukken
Inhoudsopgave
