Onderhoud - Victron energy Phoenix Multi 12/2000/100 Installatiehandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

2.4 Instellingen wijzigen met VEConfigure software

Alle instellingen kunnen gewijzigd worden met VEConfigure software

U kunt de VEConfigure software downloaden van

www.victronenergy.com

De volgende instellingen kunnen uitsluitend met VEConfigure gewijzigd worden:

- Ground relay (alleen Multi/MultPlus, standaard: on). When running on inverter the

output neutral is connected to the output ground wire and therefore also the chassis. This is

to ensure proper functioning of a GFCI (Ground Fault Circuit Interrupter), to be installed on

the AC output of the MultiPlus. In an isolated system the ground relay should be disabled.

Proper isolation of both phase and neutral from ground should then be monitored with an

isolation watch system.

- Dynamic current limit (default: off). Some modern AC generators use a static inverter to

generate the AC output. Some of these generators also reduce rpm when operating with

reduced load. By enabling the Dynamic Current Limit function (VEConfigure) the MultiPlus

can be used to assist the generator when suddenly a high load is connected.

- Alarm Relay / Virtual Switch (default: disabled)

A programmable relay is available in both the Phoenix Inverter and Multi/MultiPlus. This

relay can be used for remote alarm and other purposes (a. o. generator start signal). The

relay can be programmed with VEConfigure.

- Frequentie van de AC ingang: zie paragraaf 2.3.4.

2.5 Onderhoud

De Phoenix Multi vereist geen specifiek onderhoud. Het volstaat alle verbindingen eenmaal

per jaar te controleren. Voorkom dat de Phoenix Multi vocht en olie/roet dampen en houd

het apparaat schoon.

Inhoudsopgave

Advertenties

Inhoudsopgave