Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. TROUBLE SHOOTING TABLE
Proceed as follows for quick detection of common faults.
DC loads must be disconnected from the batteries and the AC loads must be disconnected
from the inverter before the inverter and/ or battery charger is tested.
Consult your Victron Energy dealer if the fault cannot be resolved.
Problem
Cause
The inverter fails
The battery voltage is too high
to operate when
or too low.
switched on.
The "low battery"
The battery voltage is low.
LED flashes.
The "low battery"
The inverter cuts out because
LED on.
the battery voltage is too low.
The "overload"
The load on the inverter is
LED flashes.
higher than the nominal load.
The "overload"
The inverter cuts out due to
LED on.
excessive load.
The "temperature"
The ambient temperature is too
LED flashes or is
high, or the load is excessive.
on.
The "low battery"
Low battery voltage and
and "overload"
excessive load.
LEDs flash
alternately.
The "low battery"
Voltage ripple on the DC input
and "overload"
exceeds 1.25Vrms.
LEDs flash
simultaneously.
The "low battery"
The inverter cuts out as a result
and "overload"
of excessive voltage ripple on
LEDs are on.
the DC input.
One LED alarm is
The inverter did cut out as a
on and the
result of the illuminated alarm
second LED is
indication (LED). The flashing
flashing
LED indicates that the inverter
also nearly did cut out as a
result of the relevant alarm.
22
Solution
Ensure that the battery voltage
is within the correct value.
Charge the battery or check the
battery connections.
Charge the battery or check the
battery connections.
reduce the load.
reduce the load.
Place the inverter in a cool and
well-ventilated room, or reduce
the load.
Charge the batteries, reduce
the load or install batteries with
a higher capacity. Use shorter
and/ or thicker battery cables.
Check the battery cables and
terminals.
Check the battery capacity;
increase if necessary.
Install batteries with a higher
capacity. Use shorter and/ or
thicker battery cables and reset
the inverter (switch off and on
again).
Check the table for the
appropriate course of action.
Advertenties
Inhoudsopgave
Gerelateerde Handleidingen voor Victron energy Phoenix Multi 12/2000/100
Gerelateerde Producten voor Victron energy Phoenix Multi 12/2000/100
- Victron energy Phoenix Multi 12/1300/70
- Victron energy Phoenix Multi 12/2000/120
- Victron energy SmartSolar MPPT 150/35
- Victron energy SmartSolar MPPT 150/45
- Victron energy Multi RS Solar MPPT 450/80
- Victron energy MultiPlus-II GX
- Victron energy Phoenix Multi 24/1300/40
- Victron energy Phoenix Multi 24/2500/70