Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.3.7 Special Settings (default: on)
2.3.7.1 Bulk Protection On/ Off
If the charger has not reached the absorption voltage after 10 hours' charging in the bulk
phase, the battery may be defective. In order to prevent further damage, the charger will
automatically cut out after 10 hours' bulk. The "bulk" LED will start to flash.
This safety cut out can be switched off.
Set the DS 3-7
Switch the bulk cut-out to on or off
Determine whether the bulk cut out
DS-8
should be switched on or off.
DS-7
off
The default is On.
DS-6 on
The left-hand LED column is for On.
DS-5
off
The right-hand LED column is for
DS-4 on
Off.
DS-3
off
Press the pushbuttons until the
DS-2
required LED indication is
DS-1
displayed.
2.3.7.2 AC Waveform Check (default: on)
The Phoenix Multi checks if the mains voltage has not only the correct voltage, but also the
correct shape. When the Phoenix Multi does not function properly on a generator this
function can be disabled.
Set the DS 3-7
Switch the Mains Voltage Check to
on or off
Determine whether the Mains
DS-8
Waveform Check should be
DS-7
off
switched on or off.
DS-6 on
The default is On.
DS-5
off
The left-hand LED column is for On.
DS-4
off
The right-hand LED column is for
DS-3 on
Off.
DS-2
Press the pushbuttons until the
DS-1
required LED indication is
displayed.
Example
Required: bulk cut out is off.
LED indication =
On
Off
Example
Required: Mains Waveform
Check is off.
LED indication =
On
Off
17
Advertenties
Inhoudsopgave
Gerelateerde Handleidingen voor Victron energy Phoenix Multi 12/2000/100
Gerelateerde Producten voor Victron energy Phoenix Multi 12/2000/100
- Victron energy Phoenix Multi 12/1300/70
- Victron energy Phoenix Multi 12/2000/120
- Victron energy SmartSolar MPPT 150/35
- Victron energy SmartSolar MPPT 150/45
- Victron energy Multi RS Solar MPPT 450/80
- Victron energy MultiPlus-II GX
- Victron energy Phoenix Multi 24/1300/40
- Victron energy Phoenix Multi 24/2500/70