Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Use of the function "selectable welding time"
16.7
When there are fluids in the bag and hence in the section where you want to seal it, the
welding procedure should be adjusted to "feucht". This would increase the welding time
and the bag is safely sealed. Press the button "Lebensmittel trocken & feucht". If the lamp
will illuminate above "feucht", the welding time for moist vacuum food is adjusted.
16.8 Vacuum package in a Canister
Wipe canister cover, canister base and ensure they are
clean and dry.
Put the items into the canister and do not fill up too full so
that the cover can be in good contact with the canister bowl
rim. Close the cover.
Insert one end of the hose into the air intake and another
end of the hose into the center hole of the canister cover.
Check the LED status of "vacuumstrengh" and make sure if
it is in "normal" setting.
Close the cover. Turn the lever clockwise until the cover is latched.
Press the "Behälter" (Canister) button to start vacuuming. To ensure there is no air leaking
between the cover and the canister, use your hand to push down the cover at the
beginning of the vacuuming work. The machine will stop automatically when enough
vacuum pressure is achieved.
Take out the hose tube from the canister or bowl immediately first after the job is
completed.
16.9 Marinate with a Canister
Wipe canister cover, canister base and ensure they are clean and dry.
Put the items into the canister and do not fill up too full so that the cover can be in good
contact with the canister bowl rim. Close the cover.
Insert one end of the hose into the air intake and another end of the hose into the center
hole of the canister cover.
Check the LED status of "vacuumstrength" to confirm the desired vacuum pressure
"normal" (normal) or "soft" (gentle) according to the type of food.
Close the lid. Turn the lever clockwise until the cover is latched.
Press "Marinieren" (marinate) button to start working.
The indicator light has been on during the course. It will release air automatically after
finished vacuum, the device will work for 5 cycles.
When the indicator light crush out, the marinate process is completed. Pull off the hose
accessory from canister port and canister cover.
16.10 Use of the cutter
To cut the foil at desired length, press und cutter unlock buttons on both sides. Press down
the cutter so that the foil is held firmly. Slide the cutter over the foil.
Push it back into place until it latches.
47
Advertenties
Inhoudsopgave
