Advertenties
Beschikbare talen
Beschikbare talen
14 | English
Problem
Possible Cause
Parts of the lawn
Mower requires more cuts to
area left uncut
finish garden
Time slot not long enough for
garden size
Distance between perimeter
wires too small
Rough mowing conditions
Grass too long
Slopes in garden too steep
Mower gets stuck in
Objects/obstacles not marked
garden
out
Newly laid turf
Mower
Objects/obstacles below 5 cm
unintentionally cuts
not marked out
flowers, etc . or
runs over certain
obstacles
Mower does not
Map & Mow system depends on
appear to cut
the garden conditions . Mower
logically
does not necessarily have to
continue in the next uncut area .
Mower does not always go in
a straight line when travelling
between areas
Mower frequently does not
find right position or turns on
the spot
Wire crossed while marking an
object
Mower runs in random paths
in an additional lawn without
docking station .
Perimeter wire keeps
Wire is not taut between pegs
being cut
Distance between pegs is more
than 75 cm
Corrective Action
Allow mower to run for 3 full cuts to cover whole lawn
area .
Increase mowing time slot or use Honda "Smart Timer"
Calendar Function .
Increase distance between the perimeter wires to a
minimum of 75 cm .
Select "uneven ground/low sensitivity" option from
menu item "lawn condition/bump sensor" .
Flatten garden/remove/bumps/mark out unsuitable areas
with the perimeter wire – Please follow the instructions
in the Installation Guide .
Select "uneven ground/low sensitivity" option from
menu item "lawn condition/bump sensor" .
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope .
Use the perimeter wire to mark off obstacles where the
mower often gets stuck .
Allow a few weeks for the soil to settle before using the
mower .
Select "uneven ground/low sensitivity" option from
menu item "lawn condition/bump sensor" .
After watering, wait as long as possible until you start
the mower .
Mark obstacle using perimeter wire leaving 30 cm from
object or remove objects/obstacles .
Further information can be found on the Installation
Guide .
If behaviour re-occurs often, remap garden .
No corrective action needed .
Change wire ID .
Follow instructions in the Installation Guide .
Normal behavior . The Map & Mow system only works in
areas with docking station .
Make wire taut and ensure distance between pegs is
maximum 75 cm . Follow instructions in the Installation
Guide . Use the wire connectors to repair the cut .
Advertenties
Probleemoplossen
