Inhoudsopgave
Advertenties
Installing the product
Install the product in accordance with Figures A, E:
1. Rotate the solar cell housing
shade
(see Fig. A).
5
2. Move the ON / OFF switch
the product switching on during darkness.
3. Insert the solar cell housing
tighten by turning it clockwise.
4. Pull out the base
inside the lamp body
5. Insert the base
6. Insert the ground spike
downwards (see Fig. E).
7. Your product is ready for use.
Setting up the product
Insert the assembled product far enough into the ground (lawn,
flower bed) for it to be stable. Make sure you keep proper footing
and balance at all times. Do not use any force when assembling
or setting-up the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the product up in
a place where the solar cell will get direct sunlight for as long as
possible (see Fig. F). Make sure that the solar cell is not influenced
by any other source of light such as yard or street lighting as other-
wise the product will not come on in twilight. The product automati-
cally switches on in twilight conditions and off again when normal
outdoor lighting conditions return.
Replacing the rechargeable battery
Note: Regularly clean the sensor and solar cell to ensure proper
functionality (refer to "Cleaning and care").
26 GB/IE
4
into the "ON" position to enable
1
4
in order to take out the ground spike
11
(see Fig. A).
6
into the bottom of lamp body
11
into the base
12
anticlockwise out of the lamp
into the lamp shade
with the tip facing
11
and
5
12
(see Fig. E).
6
Advertenties
Hoofdstukken
Inhoudsopgave
