Inhoudsopgave
Advertenties
28 | English
fault. There is risk of injury from unintentionally pressing
the on/off switch.
Cutting tips (see fig. J − L)
Never operate the tool in an awkward posture. This may
cause serious injury without gloves or whilst the battery is in-
serted.
Always keep both hands on the machine when using it.
Never touch the blades without gloves or whilst the bat-
tery is inserted.
The tool is intended to be used by the operator at ground
level and not on ladders or any other unstable support.
You can use the 360° trigger (6) to hold the machine in dif-
ferent working positions.
Troubleshooting
The following table provides common troubleshooting information. The battery-charge indicator provides additional informa-
tion that can be used to identify a malfunction or problem.
Problem
Possible Cause
LED's are flashing
Branch is too hard to cut
Battery or machine is overheated
Other faults
Cutting head is not working
Internal drive linkage is not fully engaged
or will not close
Cutting head/extension pole is incorrectly
mounted
Debris built up
Machine stops while cutting Branch is too hard to cut
Battery charge is too low
Machine is overheated
Blunt or broken blades
Internal drive linkage damaged
Reduced cutting perform-
Blunt or broken blades
ance
Battery defective
Clamping screw is loose
Machine is defective
The extension or the cutting
Incorrect alignment of the parts
head cannot be mounted.
Blades are not fully opening
Failure of the connection
F 016 L94 807 | (25.09.2024)
The 360° trigger (6) allows you to fully rotate the tool to ad-
apt the cutting head to the respective task.
Use the hook (2) to pull already cut entangled branches to-
wards you.
If the blade gets stuck in a branch, slightly pivot the tool back
and forth in the cutting direction.
Always wear recommended personal protective equipment
while pruning.
Never cut too close to the trunk to ensure healthy regrowth.
If you remove an entire stem, cut back to the point where it
branched.
Cut branches one by one.
Remove thin or weak growth.
Always remove dead, damaged and diseased branches.
Corrective Measure
Try cutting in a thinner area of the branch.
Allow battery and machine to cool down
Contact Service Agent
Manually push the blades together
Mount the cutting head/extension cor-
rectly (see "Mounting/Dismounting the cutting
head (see figures B − C)", page 27) and (see
"Mounting/Dismounting the extension (see
figures D − E)", page 27)
Remove debris from blade
Try cutting in a thinner area of the branch.
Recharge battery.
Allow machine to cool down
Replace blades/cutting head
Contact Service Agent
Replace blades/cutting head
Replace battery
Contact Service Agent.
Contact Service Agent.
Mount the cutting head/extension cor-
rectly (see "Mounting/Dismounting the cutting
head (see figures B − C)", page 27) and (see
"Mounting/Dismounting the extension (see
figures D − E)", page 27)
Refit and perform cutting cycle
Contact Service Agent
Bosch Power Tools
Advertenties
Inhoudsopgave
