Inhoudsopgave
Advertenties
en
Check Robolinho, base station and cable re-
gularly for damage
Have damaged parts and batteries replaced
or repaired by an AL-KO dealer, technician or
service partner
Transport
Only carry the Robolinho by its deck.
Stop the Robolinho using the [STOP key]
(3-2).
Switch off the Robolinho using the [ON/OFF
key] (3-7).
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
Cleaning
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
1
Once a week, thoroughly clean the automatic
lawnmower with a hand brush or cloth.
Contamination can impair the function of
the machine if not removed.
2
Once a week, check the cutting blades (2-9)
for damage.
Damage to the electrical/electronic
system by incorrect cleaning!
Do not clean the automatic lawnmower
with a high-pressure cleaner or under
running water. Water penetration can
cause irreparable damage to the switch,
battery, motors and circuit boards.
Checking contacts
1
If the contact surfaces (12-2) on the automa-
tic lawnmower are contaminated, clean them
with a cloth.
Charring on the contact surfaces indica-
tes a poor charging contact.
Bend the springs on the base station
outwards (10-1).
Cleaning the chassis
1
Thoroughly clean grass catcher (13-5) and
guide (13-7) using a hand brush or a cloth.
36
Check the rollers can move freely
1
Once a week, thoroughly clean the areas
around the rollers (13-1) with a hand brush or
cloth.
2
Check the rollers (13-1) can move and steer
freely.
If the rollers (13-1) do not move freely,
they must be freed up or renewed.
Checking the base station
1
Disconnect the mains plug on the transfor-
mer.
2
Check the contacts (10-1) on the base station
for contamination and clean using a cloth if
necessary.
3
Push the contacts towards the base station
and release.
The contacts must spring back into the
initial position.
If the contacts do not spring back into the
initial position, have them checked by an
AL-KO dealer, technician or service part-
ner, and renewed if necessary.
Checking the base station
Before storage (winter) of the Mähroboters follo-
wing points should be noted:
Fully recharge the battery.
Off Lawn Mower.
Clean Lawn Mower.
Replace damaged cutting blade.
Lawnmower Store in a dry, frost-free room.
REPAIR
Repair work is only allowed to be carried out by
expert workshops or our AL-KO service centres.
Repair work is only permitted using original spare
parts.
Renewing the cutting blades
1
Switch off the automatic lawnmower (3-7).
2
Put down the automatic lawnmower with the
cutting blades pointing upwards.
3
Unscrew the screws (2-11) with a 5.5 mm
spanner.
4
Pull the cutting blades (14-5) out of the blade
seat.
5
Clean the blade seat with a soft brush.
Maintenance
Robolinho
4000
©
Advertenties
Hoofdstukken
Inhoudsopgave
