Inhoudsopgave
Advertenties
8.1
Switching the camera system on
1.
Ensure that the monitor is switched on.
POWER
2. Press the
The camera system switches on.
8.2
Calibrating the camera system
WARNING! Health hazard
Ensure that all areas around the vehicle are displayed by the video system. Blind spots pose a safety
risk.
NOTE
Avoid strong shadows on the calibration mats.
Ensure uniform illumination, preferably in daylight.
2 calibration mat must be fully visible in each camera. Use the 4 fisheye views shown for orien-
tation.
1.
Attach the calibration mats at each corner of the vehicle.
Fig.
on page 12
2. If necessary, apply colored tape in straight lines at a distance of 10 cm around the vehicle.
NOTE The tape helps to fine-tune the width and length of the vehicle graphics.
3. Switch on the vehicle ignition to activate the camera system.
4. Set up and configure the camera system.
Follow the instructions in the configuration guide (see
9
Disposal
Recycling products with non-replaceable batteries, rechargeable batteries, or light sources:
•
If the product contains any non-replaceable batteries, rechargeable batteries, or light
sources, you don't have to remove them before disposal.
•
If you wish to finally dispose of the product, ask your local recycling center or specialist dealer
for details about how to do this in accordance with the applicable disposal regulations.
•
The product can be disposed free of charge.
Place the packaging material in the appropriate recycling waste bins wherever possible. Consult
a local recycling center or specialist dealer for details about how to dispose of the product in accor-
dance with the applicable disposal regulations. The product can be disposed free of charge.
22
button on the remote control.
Related
documents).
Advertenties
Inhoudsopgave
