Inhoudsopgave
Advertenties
CAUTION! Risk of injury
Failure to obey these cautions could result in minor or moderate injury.
Secure any parts of the system concealed by the bodywork in such a manner that they cannot
become loose or damage other parts or cables, or impair vehicle functions (steering, pedals,
etc.).
Always follow the safety instructions of the vehicle manufacturer. Some work (e.g., on reten-
tion systems such as the airbag, etc.) may only be performed by qualified specialists.
NOTICE! Damage hazard
To prevent damage when drilling ensure that there is sufficient space on the other side for the
drill head to emerge.
Deburr all drill holes and treat them with a rust-protection agent.
When working on the electrical system, the batteries must be separated from the vehicle
ground. This applies to the main and additional batteries.
When working on the following cables only use insulated cable lugs, plugs and tab sleeves:
•
30 (direct input from positive battery terminal)
•
15 (connected positive terminal, behind the battery)
•
31 (return cable from the battery, ground)
•
58 (reversing light)
Do not use porcelain wire connectors.
Use a crimping tool to connect the cables.
Screw the cable when connecting cable 31 (ground).
•
Screw the cable using a cable lug and lock washer to one of the vehicle's ground bolts
or
•
Screw the cable to the sheet metal body work using a cable lug and a self-tapping
screw.
Ensure that there is a good ground connection.
If the battery is disconnected, all data stored in all volatile memory will be lost. Data may have
to be reset. Follow the instructions of the vehicle manufacturer in this case. The instructions
for making these settings can be found in the operating manual.
When testing the voltage in electrical cables only use a diode test lamp or a voltmeter. Test
lamps with a bulb consume too much voltage which can damage the vehicle's electronic sys-
tem.
When making electrical connections ensure the following:
•
They are not kinked or twisted.
•
They do not rub on edges.
•
They are not laid in sharp-edged through-holes without protection.
Insulate all connections.
Secure the cables against mechanical stress with cable binders or insulating tape, e.g., to ex-
isting lines.
Follow the installation and operating manual for the monitor.
Do not open the camera.
Do not pull the cables.
Do not expose the cables to solvents such as benzene for long periods of time.
Do not use the cameras under water.
15
Advertenties
Inhoudsopgave
