Inhoudsopgave
Advertenties
All manuals and user guides at all-guides.com
Test out which setting suits your personal preference.
The grinding process begins once the start/stop button has been
pressed (6). The motor only runs if the collection container (7) has
been put in place properly.
Once the required amount of coffee has been ground, the mill shuts
off automatically.
The grinding process can be interrupted at any time by pressing the
start/stop button (6) again.
Wait until the motor has stopped before removing the collection con-
tainer (7). Press down slightly when removing the collection container
(7). The coffee powder can be placed directly in the coffee machine
filter.
To avoid loss of aroma, coffee should only be milled for immediate use.
Excess coffee grounds can be kept in the collection container (7). Then
close the collection container (7) with the rubber cap (1).
Important information:
If the mill does not run, the motor may be obstructed by a bean. In
this case select a higher degree of fineness. Once the motor is running
the desired degree of fineness can be immediately reselected after
start-up.
If the motor still does not start, or has difficulty starting up at the
highest degree of fineness, clean the mill as described under „Cleaning
and Care".
Cleaning and care
Warning! Remove from the mains before cleaning. Under no circum-
stances submerge the device in water - wipe the outside with a damp
cloth instead.
Do not use scourers.
Remove the collection container (7) and clean with a mild cleaning
product. Dry well before replacing the collection container (7).
Remove the remaining beans before removing the bean hopper (3).
Clean the bean hopper (3) and bean hopper cap (2) in dish water and
dry well. The mill can be opened when malfunctions occur or for clea-
ning. Remove the bean hopper (3) and then remove the mill ring (8).
Clean the mill and the mill ring (8) with a small brush or the cleaning
brush included in delivery (9).
Warning: The mill has sharp edges - there is danger of injury.
Replace the mill ring (8) and turn until it clicks into place and only
moves slightly.
Important: The safety ring must be turned in a clockwise direction as
far as it can go (see illustration) before the bean hopper (3) is replaced.
Otherwise the bean hopper (3) cannot be put back in place. Should
the safety ring be incorrectly replaced during cleaning, you can turn it
manually to the left.
8
Advertenties
Inhoudsopgave
