Inhoudsopgave
Advertenties
Total hardness
Iron
Manganese
Copper
Active chloride
free of bad odours
* Maximum total 2000 μS/cm
** Test volume 1 l, settling time 30 min
*** no abrasive substances
Safety instructions
Please follow the national rules and
regulations for fluid spray jets of the re-
spective country.
Please follow the national rules and regu-
lations for accident prevention of the re-
spective country. Fluid spray jets must be
tested regularly and the results of these
tests must be documented in writing.
The appliance/accessories must not be
modified.
DANGER
– Do not use high pressure cleaners
when there has been an oil spill; move
the appliance to another spot and avoid
any sort of spark formation.
– Do not store, spill or use fuel in the vi-
cinity of open flames or appliances such
as ovens, boilers, water heaters, etc.
that have an ignition flame or can gen-
erate sparks.
– Keep even mildly inflammable objects
and materials away from the muffler (at
least 2 m).
– Do not start the engine without the muf-
fler; check, clean and replace, if re-
quired, the muffler at regular intervals.
– Do not use the engine in forest, bushes
or grassy areas without fitting a spark
receiver at the exhaust
– Except for setting jobs, do not run the en-
gine when the air filter is removed or there
is no cover over the suction support.
– Do not make any adjustments to the
regulator springs, regulator bars or oth-
er parts that can bring forth an increase
in the engine speed.
< 28 °dH
< 50 °TH
< 500 ppm
(mg CaCO
/l)
3
< 0,5 mg/l
< 0,05 mg/l
< 2 mg/l
< 0,3 mg/l
– 3
EN
– Risk of burns! Do not touch hot muf-
flers, cylinders or radiator ribs.
– Do not put hands or feet close to mov-
ing or rotating parts.
– Risk of poisoning! The appliance should
not be operated in closed rooms.
– Do not use unsuitable fuels, as they
may be dangerous.
Safety Devices
Safety devices serve for the protection of the
user and must not be put out of operation or
bypassed with respect to their function.
Overflow valve
– If the hand spray gun is closed, the
overflow valve opens and the high pres-
sure pump diverts the water back to the
pump suction side. Thus the permissi-
ble working pressure is not exceeded.
– The overflow valve is set by the manu-
facturer and sealed. Setting only by
customer service.
Safety valve
The safety valve opens when the permissi-
ble operating pressure is exceeded (see
Technical Data); water flows outside.
The safety valve is set by the manufacturer
and sealed. Setting only by customer service.
Thermostat valve
The thermostat valve protects the high-
pressure pump from unacceptable heating
during circuit operation when the trigger
gun is closed.
The thermostat valve opens when the permis-
sible water temperature of 80°C is exceeded
and lets out the hot water into the open.
Start up
DANGER
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. If they are not in a perfect state
then the appliance must not be used.
Installing the pushing handle
Figure 3, see cover page
Fasten the push handle by means of
the fastening screws.
17
Advertenties
Hoofdstukken
Inhoudsopgave
