Advertenties
BSL 2470
3.
Operation
3.1
What you need to know and observe before
charging batteries
3.1.1
General tips
i
Every battery charging process should be
preceded by a battery test using a Bosch
battery tester in order to assess the exact con-
dition of the battery about to be charged.
The battery charger should be placed on a
steady, horizontal base. The location must
be sufficiently stable. Note the weight of
the device and that of the battery to be
charged.
Protect the battery charger against humi-
dity and moisture.
Do not remove the battery charger's cover.
Place the battery charger in a location
where it has at least 15 cm of free air sur-
rounding it for ventilation purposes.
Robert Bosch GmbH
3.1.2
Important notes on charging batteries
Wear protective goggles. Clean any acid
splashes off your skin or clothing immedia-
tely, using copious amounts of water to do
so. If necessary you should visit a doctor.
Batteries should only be charged on well-
ventilated premises.
Avoid any fires, naked flames and sparking
when charging the battery.
Explosive gases are generated during the
charging process.
Pungent gas fumes are an indication of im-
minent danger of explosion!
Proceed as follows:
1.
Do not switch off the battery charger! Avo-
id fire, naked flame and any sparking!
2.
Do not disconnect the charger's crocodile
clip-on terminals!
3.
The room is to be well ventilated imme-
diately!
4.
Set the rotary control to its furthermost
left-hand setting (lowest battery charge
current)!
5.
After ventilating the room switch the po-
wer switch on the charger to „0" (OFF)!
6.
Have the battery checked by a Bosch Ser-
vice Point.
When charging batteries in the vehicle or
where performing a start-assist measure, fol-
low the vehicle manufacturer's instructions.
Only tested batteries should be used in
parallel to charge a battery.
Do not charge absolutely maintenance-free
batteries together with standard batteries
(maintenance free as under DIN).
Do not attempt to charge a non-chargeable
battery.
Switch off all consumers in the vehicle when
charging exhaustive discharge batteries and
when performing a start-assist measure.
The battery nominal voltage and the selec-
ted battery charging current must match.
The mains supply cable and the battery
charger cables with the crocodile clips
must be in perfect condition.
de 17
en
es fr
fi pt nl sv it
1 689 979 848 (2005-06-14)
Advertenties
