Download Inhoudsopgave Inhoud Print deze pagina

Lubricating Oil For The Saw Chain (Fig. D); Operation; Before Using A New Chain Saw - VARO Powerplus POWXG1040 Vertaling Van De Originele Handleiding

Snoeizaag 12 v, 100 mm
Inhoudsopgave

Advertenties

Hold the chain in position on the bar and place the loop around the sprocket (15).
Fit the bar flush against the mounting surface so that the bar studs are in the long slot of
the bar.
NOTE: When placing the bar on the bar studs, ensure that the adjusting pin
is in the chain tension pin hole.
Replace the sprocket cover (3).
Replace the sprocket cover knob (4). Turn the knob clockwise to tighten the sprocket
cover. The bar should still be free to move for tension adjustment.
Remove all slack from the chain by turning the chain tensioning screw (16) clockwise until
the chain seats snugly against the bar with the drive links in the bar groove.
Lift the tip of the guide bar up to check for sag.
Release the tip of the guide bar turn the chain tensioning screw (16) 1/2 turn clockwise.
Repeat this process until sag does not exist.
Hold the tip of the guide bar up and tighten the sprocket cover knob. The chain is correctly
tensioned when there is no sag on the underside of the guide bar, the chain is snug, but it
can be turned by hand without binding.
NOTE: If the chain is too tight, it will not rotate. Loosen the sprocket cover
lock knob slightly, turn the chain tensioning screw 1/4 turn anti clockwise.
Lift the tip of the guide bar up and retighten the chain cover lock knob.
Ensure that the chain will rotate without binding.
10.2

Lubricating oil for the saw chain (Fig. D)

Before starting up your new chain saw, the chain has to be lubricated manually. (Available
in our product range: POWOIL003 - 1L & POWOIL006 - 5L.)
It allows operating the chain saw at ambient temperatures down to as low as -15 °C.
Never use waste oil for lubricating the saw chain.
1.
Switch off the saw and remove the battery.
2.
Place the saw on a level surface.
3.
Clean the guide bar and chain with a soft brush and solvent.
4.
Apply oil in area (a) between the guide bar an chain (Fig. D).
5.
Refit the battery and run the saw until the oil is evenly distributed over the chain.

11 OPERATION

11.1

Before using a new chain saw

Please read this manual carefully.
Fully charge the battery before using it the first time. See instructions under the heading
"Charging the battery".
Check that the cutting equipment is correctly fitted and adjusted. See instructions under
the heading "Assembly".
Do not use the chain saw until sufficient chain oil has reached the chain.
Long-term exposure to noise can result in permanent hearing impairment. So always use
approved hearing protection.
Copyright © 2024 VARO
POWXG1040
P a g e
| 9
EN
www.varo.com

Advertenties

Inhoudsopgave
loading

Inhoudsopgave