Inhoudsopgave
Advertenties
7.2
Chargers
▪
Never attempt to charge non-rechargeable batteries.
▪
Have defective cords replaced immediately.
▪
Do not expose to water.
▪
Do not open the charger.
▪
Do not probe the charger.
▪
The charger is intended for indoor use only.
8 CHARGING AND INSERTION OR REMOVAL OF BATTERY
8.1
Charger indications (Fig. B)
Charger indicator LED (11):
▪
Solid red: charging.
▪
Solid green: charged.
Note: If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery pack
that does not securely fit the charger.
▪
Frequently monitor the charger and battery pack while connected.
▪
Unplug the charger and disconnect it from the battery pack when finished.
▪
Allow the battery pack to cool completely before using it.
▪
Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
WARNING: Before making any adjustments ensure the tool is switched off or
remove the battery pack.
8.2
Charging the battery (Fig. B)
▪
Connect the power adapter (10) to a power outlet socket.
▪
Insert the charging cable onto the battery pack, the red LED (11) will light up.
▪
The green LED (11) will light up when the battery pack is fully charged.
▪
The charging cable can simply be pulled out of the battery pack.
8.3
Removal / insertion of battery (Fig. A & B)
▪
Hold the tool with one hand and the battery pack (9) with the other.
▪
Push in the battery pack, it will not fit the tool if the position is wrong.
▪
To remove: Press the battery release latches (12) and pull the battery pack out at the
same time.
8.4
Battery capacity indicator (Fig. A & B)
There are battery capacity indicators (13) just below the trigger switch (5), you can check the
capacity status of the battery by pressing the trigger switch (5). Before using the machine,
please press the trigger switch to check if the battery is full enough for proper working.
Those 3 LEDs (11) show the status of the capacity level of the battery:
▪
3 LED's are lit: Battery fully charged.
▪
2 LED's are lit: Battery 60 % charged.
▪
1 LED is lit: Battery almost discharged.
Copyright © 2024 VARO
POWXG1040
P a g e
| 7
EN
www.varo.com
Advertenties
Hoofdstukken
Inhoudsopgave
