Advertenties
Beschikbare talen
Beschikbare talen
Operating manual SATA air star C
EN
■ Check bands and rubber seal for damage and replace if necessary (see
chapter 10.4).
■ Pull the loops on the head straps [3-1] up to the end of the head
bands.
■ Completely pull the lower bands through [3-3] until the head strap
loops are up against the mask cap.
■ Pull lower bands [5-3] over the head.
■ Guide breathing air tube [4-1] and [4-2] over the head.
■ Place half mask [5-2] over mouth and nose.
■ Place the head straps [5-1] on the back of the head and guide them
along above the ears [6-1].
■ Tighten both ends of the head bands [6-2] and [6-4] until the half mask
fits firmly on the face.
■ Balance the head bands as well as lower bands and re-adjust them
until the half mask fits comfortably and firmly on the face.
9.4. Leak test of the half mask
■ Inhale briskly to check for leaks.
■ Hold breath briefly. It should be possible to feel a slight vacuum within
the half mask.
■ At no time may any air from outside get into the half mask in the area of
the rubber seal.
■ If the vacuum is compensated, the half mask needs to be adjusted.
Adjust the half mask
■ Tighten both ends of the head band [6-2] and [6-4] until half
mask [6-3] is completely fitted to the face.
9.5. Putting into operation
■ Connect spray gun compressed air tube [1-5] / [2-5] to the air connec-
tion of the spray gun.
■ Connect spray gun compressed air tube to the air connection [7-9] / [2-
8].
■ Connect breathing air tube [1-2] / [2-2] to the air connection [7-7] / [8-
4].
Option
■ Connect breathing air tube [1-2] / [2-2] to the air connection [1-
3] / [2-3] of the respiratory humidifier top air [1-4] / [2-4].
■ Connect compressed air supply [1-7] / [2-6] to the air connection [7-
6] / [8-3] of the belt unit.
■ Open the cut-off valve of the air connections [1-11] / [2-8] and [2-9].
110
Advertenties
