14 www.electrolux.com
a water softener can damage
the ice maker.
7.6 Ice maker/dispenser tips
• If refrigerator is not connected to a
water supply or the water supply is
turned off, turn off the ice maker as
described in the previous section.
• The following sounds are normal when
the ice maker is operating:
- Motor running
- Ice dropping into ice bin
- Water valve opening or closing
- Running water
• If a large quantity of ice is needed at
one time, it is best to get cubes directly
from the ice bin.
• Ice cubes stored too long may develop
an odd flavor. Empty the ice bin as
explained below.
• When dispensing cubed ice, it is
normal to have a small quantity of little
pieces along with the whole cubes.
• To avoid splashing, dispense ice into
the container before adding liquids.
• It is normal for ice to fill to the top of
the ice bin.
7.7 Cleaning the ice maker
Clean the ice maker and ice bin at
regular intervals, especially prior to
vacation or moving.
1. Turn off the ice maker.
2. Remove the ice bin by pulling
straight out.
3. Empty and carefully clean the ice bin
with mild detergent. Do not use harsh
or abrasive cleaners. Do not place in
dishwasher. Rinse with clear water.
4. Allow the ice bin to dry completely
before replacing in the freezer.
5. Replace the ice bin. Turn the ice
maker on.
Remove and empty the ice
bin if:
• An extended power failure (one hour
or longer) causes ice cubes in the
ice bin to melt and refreeze together
after power is restored, jamming the
dispenser mechanism.
• Ice dispenser is used infrequently. Ice
cubes will freeze together in the bin,
jamming the dispenser mechanism.
Remove the ice bin and shake to loosen
the cubes or clean as explained above.
CAUTION
NEVER use an ice pick or similar
sharp instrument to break up the
ice. This could damage the ice
bin and dispenser mechanism.
To loosen stuck ice, use warm
water. Before replacing the ice bin,
make sure it is completely dry.
IMPORTANT
When removing or replacing the
ice bin, avoid rotating the auger
in the ice bin. If the auger is
accidentally rotated, realign the
auger by turning it in 45 degree
turns (see below) until the ice
bin fits into place with the drive
mechanism. If the auger is not
properly aligned when replacing
the ice bin, the refrigerator will
not dispense ice. The fresh food
door also may not close properly
causing warm air to leak into the
fresh food compartment.