Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3 EQ (HI, MID, LOW) controls
4 FILTER control
5 Headphones CUE button
6 Channel fader
7 Crossfader
8 MASTER LEVEL control
9 BOOTH MONITOR control
a HEADPHONES MIXING control
b SAMPLER VOLUME control
c Channel Level Indicator
d Master level indicator
Effect section
The effect section is used to control the two effect units (FX1 and FX2).
Controls and buttons used to operate the FX1 unit are located on the left
side of the controller, and those used to operate the FX2 unit are located
on the right side of the controller. Set the target channels to apply the
effects to using the effect assign buttons on the mixer section.
Rear panel
1
2
1 Kensington security slot
2 BOOTH terminals
3 MASTER 2 terminals
4 MASTER 1 terminals
Be careful not to accidentally insert the power cord of
another unit to [MASTER 1] terminal.
Do not connect the terminal that can supply phantom
power to the [MASTER 1] terminal.
5 PHONO/LINE input terminals
6 PHONO/LINE switches
7 SIGNAL GND terminal
Connect a ground wire of an analog player to reduce noise that
occurs when an analog player is connected.
8 MIC terminal
9 USB port
a DC IN terminal
b Cord hook
8
En
3
4
5
1
3
1 Effect parameter controls
2 FX BEATS control
3 Effect parameter buttons
4 FX 1 ASSIGN button
5 FX 2 ASSIGN button
Front panel
1
2
1 PHONES jacks
2 HEADPHONES LEVEL control
3 MIC LEVEL control
6 7
5
8
c STANDBY/ON switch
This switch is used to switch between standby and on.
2
4
5
9
a
b
c
3
Advertenties
Hoofdstukken
Inhoudsopgave
