Advertenties
Beschikbare talen
Beschikbare talen
that may come in contact with the terminals and cause a short circuit. Comply with the locally
applicable regulations for transporting batteries.
▶
Do not send batteries through the mail. Consult your shipper for instructions on how to ship
undamaged batteries.
▶
Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits
stated in the technical data.
▶
Do not store batteries on the charger. Always remove the battery from the charger when the
charging operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized
persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed
Status indicators of the Liion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem
by yourself, contact Hilti Service.
Trouble or fault
LEDs of the battery show
nothing
The on/off button cannot be
pressed, i.e. the button is
locked.
Running speed suddenly
drops considerably.
Chips are not transported
away; they drop on to the
base plate
The product doesn't restart
by itself after the saw blade
has stalled.
The battery does not en-
gage with an audible click.
Product vibrates more than
usual.
32
Possible cause
Battery defective
Not a fault (safety function).
The battery is discharged.
Saw advance pressure is too
high.
The chip / dust channel is
blocked.
The overload cut-out has been
activated.
The retaining lugs on the battery
are dirty.
The saw blade is fitted incorrect-
ly.
Action to be taken
▶
Contact Hilti Service.
▶
Press the switch-on interlock.
▶
Charge the battery.
▶
Reduce advance pressure and
switch the power tool back
on.
▶
Clean the chip ejector channel.
31
▶
Press the switch-on interlock
and the on/off button again.
▶
Clean the retaining lug and
re-insert the battery.
▶
Remove the saw blade and
refit it correctly.
2276609
*2276609*
Advertenties
