Advertenties
Beschikbare talen
Beschikbare talen
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels
of moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
• Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate
unnecessarily on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not
use cleaning agents containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the
contacts.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone
as these can attack the plastic parts.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that
they all function correctly.
• Do not use the product if signs of damage are found or if parts malfunction. Immediately have the
product repaired by Hilti Service.
• After cleaning and maintenance, install all guards and protective devices and check that they are
in full working order.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables.
Spare parts, consumables and accessories approved by Hilti for use with your product can be
found at your Hilti Store or online at: www.hilti.group
Cleaning the guard
1.Remove the saw blade.
2.Clean the parts of the guard carefully with a dry brush.
3.Use a suitable tool to remove deposits or cuttings from the inside surfaces of the parts of the guard.
4.Install the saw blade.
Cleaning chip ejector channel
1.Remove the saw blade.
2.Pull the chip collector up out of the guides.
3.Clean the chip ejector channel with a brush.
Checks after cleaning and maintenance
After cleaning or maintenance, check that all safety devices are fitted and that they function faultlessly.
1.To check the pivoting guard, open the guard fully by moving the guard operating lever.
▶
The pivoting guard must close quickly and completely when the guard operating lever is released.
2.Check that the moving parts are in full working order, e.g. not binding or rubbing.
3.Examine the product for breakages and other visible damage.
Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery/batteries.
▶
Never transport batteries loose and unprotected. During transport, batteries should be protected
from excessive shock and vibration and isolated from any conductive materials or other batteries
*2276609*
29
29
29
2276609
31
Advertenties
