Advertenties
Beschikbare talen
Beschikbare talen
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and
the Hilti tool tether #2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool
tether.
Removing the saw blade
WARNING
Risk of burns and cut injuries at saw blade, clamping screw and clamping flange The
consequences can be burns and cut injuries.
▶
Wear protective gloves when changing saw blades.
1.Press and hold down the spindle lock button (1).
2.Use the hex key to slacken the clamping screw (2).
3.Remove the clamping screw and the clamping flange (3).
4.Open the pivoting guard (4) and remove the saw blade (5).
If necessary, the mounting flange can be removed for cleaning.
Installing the saw blade
Check that the blade to be fitted complies with the technical requirements and that it is well
sharpened. A sharp saw blade is an essential requirement for a perfect cut.
1.Clean the mounting flange and the clamping flange.
2.Slip the mounting flange right way round on to the arbor (1).
3.Open the pivoting guard (2).
4.Insert the new saw blade.
Note the direction-of-rotation arrows (3) on the saw blade and on the product. They must
point in the same direction.
5.Place the outer clamping flange in position, right way round (4).
6.Install the clamping screw.
7.Insert the hex key into the saw blade clamping screw.
8.Press and hold down the spindle lock button (5).
9.Use the hex key to tighten the clamping screw (6).
10. Check that the saw blade is seated correctly.
11. Insert the hex key into the hole provided for the purpose.
Adjusting the cutting depth
1.Release the cutting depth adjustment clamping lever.
2.Lift the product in a scissoring movement and set the cutting depth.
3.Tighten the cutting depth adjustment clamping lever.
5
Installing fence
1.Squeeze the clip together and hold it in this position.
2.Push the fence into the base plate.
▶
You can set the cutting width to suit your application.
*2276609*
2
3
4
2276609
29
Advertenties
