Advertenties
Beschikbare talen
Beschikbare talen
The following ancillary parameters are available:
Parameter
Starting
current
Starting
current-time
Hot start
Hot start-time
Dynamic arc
The welding current is automatically increased with
decreasing welding voltage. The dynamic arc specifies
the ratio between welding current and automatic
increase.
End of weld-
ing detection
(correction
value)
Mode
50 %
5...200 %
0.1 s
0.0...20 s
125 % 5...200 % X
1.0 s
0.0...20 s X
100 % 0...200 % X
100 % 0...200 % X
Parameter
Your welding machine switches the welding current off
at a particular arc length. (End of welding detection).
The parameter "SEE" can be used to adjust the maxi-
mum length of the arc.
X
X
Note
All personal settings are lost.
All welding and ancillary parameters
are reset to the factory settings (mas-
ter-reset function).
▸
Simultaneously press the buttons [18] and [8] for
at least 3 seconds.
The 7-segment display and all operating panel
3
indicators briefly illuminate as confirmation.
X
Master reset
Mode
27
Advertenties
