Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
The sensor fields become
hot.
comes on.
comes on.
and a number come on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Possible cause
The fuse is blown.
You touched 2 or more sen-
sor fields at the same time.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the
sensor field
.
The zone is not hot because
it operated only for a short
time.
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper-
ates.
The Child Safety Device func-
tion operates.
There is an error in the hob.
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error
Remedy
Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified
electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an Authorised Service
Centre.
23