Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Safety information
Important: read these instructions for
use carefully and keep them in a safe
place!
Danger to life!
• Warning. Not suitable for children! Choking
hazard – contains small parts.
• Never leave children unattended with the
packaging materials. There is a risk of suffo-
cation.
• Hang out of the reach of children.
• Do not connect the fairy lights to the mains
supply while they are still in the packaging.
• This product can be used by
children above the age of 8
and by people with reduced
physical, sensory, or mental
capacities or by those lacking
experience and knowledge
provided they are supervised
or have been instructed in the
safe use of the product and
understand the risks involved.
Children may not play with
the product. Cleaning and
user maintenance may not be
performed by children without
supervision.
Risk of electric shock!
• The product may be used only with the sup-
plied control gear (LED driver).
• Do not immerse the product, the cable or the
operating unit in water or other liquids.
• Never touch the operating unit with wet
hands.
• Never pull the operating unit out of the socket
by the cable, but always hold the operating
unit.
• Do not operate the product if it is visibly
damaged or if the cable or the operating unit
is defective.
• The product's light source is not replaceable;
the entire light must be replaced once the light
source has reached the end of its service life.
• WARNING – THESE FAIRY LIGHTS CAN-
NOT BE USED WITHOUT THE PROPERLY
ATTACHED SEALING RINGS.
Risk of injury!
• Warning. None of the packaging or fastening
materials are part of the product itself and
must always be removed for safety reasons
before the product is used.
• Check the product for damage or wear
before each use. Use the product only if it is in
perfect condition!
• Keep the product, the operating unit and
the cable away from open flames and hot
surfaces.
• Lay the power cable in such a way that it is
not a tripping hazard.
• No modifications may be made to the prod-
uct!
Preventing damage to the
product!
• Do not bend the power cable or lay it over
sharp edges.
• Never use the cable as a carrying handle.
• The product may be used only with the sup-
plied control gear (LED driver).
Use
1. Remove all packaging materials from the
product.
2. Connect the control gear (2) to the lead (1) as
shown in Fig. A.
Note: pay attention to the plus/minus poles in
the control gear.
3. Plug the operating unit into the socket.
4. Press the button (3) once to activate the prod-
uct with drip effect (Fig. B).
5. Press the button again to switch the product
on for continuous operation.
6. Press the button once more to switch the
product off.
GB/IE
9
Advertenties
Inhoudsopgave
