Advertenties
Beschikbare talen
Beschikbare talen
Once the area has been mapped and the area to be
cleaned is displayed in white on the map, the map is
saved via the app and the map creation is complet-
ed.
The display shows the time needed for the explora-
tory run.
The map is now available in the app and can be
named and adapted.
Naming and adapting the map in the app
The map can be named and adapted in the app via the
"Maps" tab.
Adaptation options in the app
● Determining no-go zones and virtual walls
● Define starting area
● Set special cleaning zones and definition of single or
double cleaning
● Defining suction strength (see chapter Suction
strength) for cleaning maps and cleaning zones
● Create schedules
Select a map on the cleaning robot and start
cleaning
Note
The cleaning robot must be placed in the starting area
marked on the map before cleaning. The starting area is
approx. 2 m x 2 m and initially corresponds to the place
where the cleaning robot started creating the map. For
easier localisation, it is recommended that the starting
area is close to surrounding walls, e.g.in a corner in-
stead of in the centre of the room. The starting area can
be subsequently moved in the app. The labels supplied
with the device can be attached to the wall or a hard
floor to mark the start area. The labels are not detected
by the device, but merely serve as a guide for the user.
Note
Check the sensors for dirt and clean them with a damp,
lint-free cloth if necessary.
1. In the "Cleaning" main menu, select the button "Ex-
isting maps".
A list of the stored maps appears on the display.
2. Select the desired map and confirm with "Confirm"
button.
The cleaning robot starts cleaning.
24
3. Once cleaning is finished, the cleaning robot returns
to the starting point.
The display shows the time needed for cleaning and
the size of the cleaned area.
A detailed cleaning report is available in the app.
Create scheduled cleaning
1. A scheduled cleaning can be created in the app via
the "Tasks" tab.
Assign card to a device
A card can be assigned to one or more cleaning robots
in the app via the "Maps" tab or via the cleaning robot
detail view.
Initially, the map is assigned to the cleaning robot with
which it was created.
Exchanging battery packs
● If the battery charge is less than 20%, a notification
appears on the display of the device and in the app
indicating the need to replace of one or both battery
packs so that the cleaning robot can continue clean-
ing.
● If the battery charge is 10%, the cleaning robot stops
cleaning and returns to the starting area. A message
appears on the display and in the app.
Note
The cleaning robot can only continue cleaning after the
battery packs have been replaced.
If the battery packs are not replaced, the cleaning robot
switches off.
1. Open the battery compartment cover.
2. Remove the battery packs (see chapter Removing
the battery pack).
3. Insert the battery packs, see chapter Fitting the bat-
tery packs.
4. Close the battery compartment cover.
5. Confirm with "Confirm" button.
Cleaning continues.
Interrupt or end cleaning
1. Press the On/Off/Pause button.
Cleaning is interrupted.
A message indicating that cleaning has been
paused appears on the display for 3 seconds.
2. Confirm with "Confirm" button or wait 3 seconds.
The options "Continue cleaning", "Back to starting
point", "End cleaning" appear on the display.
3. Select the desired setting using the arrow keys and
confirm with "Confirm" button.
Depending on the selection, the cleaning robot con-
tinues cleaning, returns to the starting point or stops
cleaning.
English
Advertenties
