Advertenties
Beschikbare talen
Beschikbare talen
4. INSTRUCTIONS FOR THE INSTALLER
The following instructions are aimed at the quali-
fi ed installer, to ensure that he carries out the in-
stallation, adjustment and maintenance operations
as correctly as possible and according to current
legal regulations. Any operation must be per-
formed with electrical power cut to the appliance.
4.1 FITTING THE FEET
The feet are inside the appliance and must be se-
cured on the four threaded holes on the base. If
4.2 POSITIONING
Position the appliance perfectly horizontally on
a table or similar support (the table or support
must be at least 85 cm above the fl oor). Once you
have put the machine, it should not exceed height
of 1.60 meter from the fl oor; position it at a dis-
tance of not less than 10 cm from the side and rear
EN
walls, to enable natural ventilating air to circulate
freely around it. The appliance is ventilated through
specifi c openings on the metal walls of the outer
housing, and ensures effi ciency and long-life. For
4.3 ELECTRICAL CONNECTION
The appliance must be connected to the electri-
cal mains according to current legal regulations.
Before making the connection, make sure of the
following:
• the voltage and frequency values of the power
supply system match the values on the „technical
data" plate affi xed on the appliance;
• the limiting valve and the system are able to
support the appliance's load (see the „technical
data" plate);
• the power supply system has an adequate earth
connection according to current legal regula-
tions;
• a omnipolar switch with minimum between-con-
tacts aperture of the overvoltage category III
(4000 V), sized to the load and conforming to
current legal regulations, is fi tted between the
6
Before using the appliance, carefully remove the
special adhesive fi lm protecting the parts in stain-
less steel. Do not leave any glue residues on the
surfaces. If necessary, remove them at once, with
an appropriate solvent.
necessary, the height of the feet can be adjusted by
screwing or unscrewing.
this reason it is strictly forbidden to obstruct these
ventilation openings, even partially or for short
periods. Failure to observe this specific prohibi-
tion releases the manufacturer of the appliance
from all responsibility and immediately voids any
guarantee rights for the said appliance, because
its constructive conformity has been voluntarily
compromised. Furthermore, the appliance is not
suitable for embedding and for grouped positioning
with other identical appliances.
appliance and the mains in the direct connection
to the mains;
• the omnipolar switch used for connection is easy
to reach when the appliance is installed;
• the yellow/green earth wire is not interrupted by
the switch;
• the power supply, when the appliance is operat-
ing, must not deviate from the rated voltage value
by ±10%;
• make sure that after inserting the power supply
cord into the terminal block it does not come into
contact with any of the cooking range's hot parts.
• if the supply cable is damaged then it must be
replaced by the manufacturer or by your techni-
cal support or by a qualified person to avoid any
risk.
Advertenties
