Advertenties
Beschikbare talen
Beschikbare talen
To allow the bow thruster or stern thruster to be distinguished
on the CAN bus, these must be configured appropriately.
Bow thruster
The configuration as supplied is for application as a bow thruster.
Stern thruster
Configure a stern thruster by cutting through the red wire as indica-
ted in the drawing.
• Reinstall the cover and tighten the glands.
Main power fuse 2
In the connection unit, there
is a main power fuse on the
controller.
This fuse protects the con-
troller and motor against
short
circuit/overloading
and it must remain present
under all circumstances.
When replacing the fuse, the replacement must be of the
same rating.
vetus® Installation manual BOW PRO Series Thrusters: BOWA0361, BOWA0364 and BOWA0421
n
ote
Red
n
ote
5.6
Connecting CAN bus (control current) cables
See diagrams from page
107
if multiple panels have to be connected.
The CAN bus power supply must always be connected to
12 Volt (≥10 V, ≤16 V). Use the E-Drive MPE1KB key switch as
power supply.
As required by international standards, all neutral (negative)
conductors of the DC system must be connected to one central
point. This prevents not only dangerous situations and corrosion
problems, but also error messages in the CAN bus system.
ENGLISH
n
ote
c
aution
020803.06
23
Advertenties
