Advertenties
Beschikbare talen
Beschikbare talen
Cleaning and maintenance
2. Unscrew the screw (fig. 7 5, page 4) out of the upper half of the housing
(fig. 7 1, page 4).
3. Carefully raise the upper half of the housing from the lower (fig. 7 6, page 4)
half.
4. Take out the contact pin (fig. 7 3, page 4).
5. Replace the defective fuse (fig. 7 2, page 4) with a new one that has the same
rating (8 A 32 V).
6. Re-assemble the plug in the reverse order.
I
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorized repair
center.
7.10
Replacing the light bulb (CDF26, CDF36, CDF46)
1. Press the switch pin (fig. 8 2, page 4) downwards so that the transparent part
(fig. 8 1, page 4) of the lamp can be removed at the front.
2. Replace the light bulb.
3. Press the lamp back into the housing.
8
Cleaning and maintenance
A
NOTICE! Damage hazard
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
➤ Occasionally clean the cooling device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
9
Warranty
The statutory warranty period applies. If the product is defective, please contact your
retailer or the manufacturer's branch in your country (see dometic.com/dealer).
18
CDF
EN
Advertenties
