Inhoudsopgave
Advertenties
5. Connect the mains terminals of the transformer to a
suitable, always on, mains supply.
Test the door camera by pressing the call button: the
confidence light should illuminate.
Note: If you have not used the door camera with batteries for
a trial test, then you must program the door camera with the
receiver by following the 'program the door camera into the
receiver' instructions.
R E C E IVE R O PE RA T IO N
When the call button is pressed on the door camera, the
receiver chimes (provided the volume switch is not set
to 0) and the camera image is displayed for about thirty
seconds. If the caller presses the call button again,
then the display time will extend to another 30 seconds.
Video transmission is limited to 30 seconds to conserve
camera battery life and is not adjustable.
Display brightness
Activate the door camera by pressing its call button,
then adjust the receiver display for best viewing by
using the four position slide switch. One step down from
maximum brightness is the recommended setting.
Chime volume control
The chime volume level can be set to using the lowest
slide switch of the three (see diagram above). Adjust to
high level (2), low level (1), or off (0).
Chime tune selection
The receiver chime tune can be changed by pressing the
' ' button.
Chime tune options are as follows:
Two note bell (Default tune for door camera)
■
Saxophone (Default tune for second door camera or
■
bell push)
Single note bell
■
Knock.
■
The ' ' button changes the chime tune for a second
door camera or a door push
Night operation
In good daylight conditions, the receiver displays a
colour picture. In low lighting or at night the display
automatically switches to black and white. Infrared
LEDs illuminate the caller, so they can be viewed on the
receiver even when surrounded by complete darkness.
Low battery indication
When the batteries in the door camera are running low,
the receiver indicates this with a double beep warning
tone that follows the chime when a visitor presses the
call button. Replace the batteries in the door camera
within one week of a low battery alert.
Tamper alert tone
If someone attempts to remove the door camera by
unscrewing the cover screws, the tamper alert tone
is triggered, beeping for 30 seconds. Check outside
immediately.
Press any button on the front of the receiver to stop
the alert tone. The alert tone is unaffected by the chime
MIC volume [for
volume switch.
future use]
Note: The alert is also triggered when you undo the cover to
Display brightness
replace batteries in the door camera.
MIC volume
Chime volume
[For future use] The topmost control along the side
(see diagram) will control the volume produced from a
microphone. Adjust for optimum listening level.
Scan button
[For future use] When used in a multi-camera system,
this button scans through available pictures.
Privacy
Remember that this product uses the public airwaves,
and that the 30-second duration video signal from the
door camera(s) can be picked up by nearby 2.4GHz video
receiving devices.
G-7
Advertenties
Hoofdstukken
Inhoudsopgave
