Inhoudsopgave
Advertenties
Mount the Door camera
Do not mount the camera in wet conditions as moisture or
condensation will affect the internal parts.
Once you have tested the system in place, mount the
camera onto a wall or door as follows:
Top
1. Remove the two screws underneath the door camera.
Unhook and release the front and pull it away from
the base. Note the TOP arrow on the base.
2. If fixing to a wall, mark the location of the
four mounting holes using the camera base
as a template. Drill using a 6mm masonry bit.
The distance between mounting holes is 72mm
horizontally and 92mm vertically.
3. Fix the door camera base in place using the screws
and wall plugs provided.
4. Hook the door camera into the base at the top first,
then push and click it in at the bottom. Check that
the unit is evenly pressed in place to seal the unit
from rain damage. Make sure that the sealing strip
on the camera front remains in place. Insert the two
screws underneath, and tighten.
Check that the unit is working after installation by
pressing the call button, the confidence light should
illuminate.
DO OR C AME RA TRANSFORME R OP T I ON
For installations where there is frequent use, typically
more than five uses per day, the door camera can
be powered using an 8 volt, 1 amp bell transformer.
Suitable Friedland transformer models are:
D753 (surface mount)
■
D780, D780S (DIN rail or surface mount)
■
Connect the low voltage output of the transformer to
the door camera using suitable low voltage cable such
as bell wire or telephone cable. Maximum recommended
outer cable diameter is 5mm. The cable run should not
exceed 30m (100ft).
A cable inlet with a water seal is provided in the rear of
the door camera. To connect up the transformer:
1. Feed the power cable through the cable inlet and
connect it to the power terminals. Leave about 15cm
(6 inches) of cable free between the base and the
door camera body, for later service access. Do not fit
batteries.
To the transformer
2. Secure the door camera in place. Check that the front
is fully and evenly pressed in to seal the unit against
rain damage.
3. Secure the cable using clips or tacks as appropriate.
4. Connect the other end of the power cable to
the secondary (8V output) of an unpowered bell
transformer. Follow the transformer instructions
carefully for correct connections.
G-6
Transformer
8V / 1A
Advertenties
Hoofdstukken
Inhoudsopgave
