Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Transport of the appliance
• During the transport, you have to secure all loose
parts in and on the appliance, in order to prevent
damage.
• The appliance should not be transported in a
vertical position and at the same time not tilted
over more than 30 degrees. Wait 30 minutes
after the installation, before you connect the
appliance to the mains.
• If the appliance was transported with a tilt of
more than 30 degrees, wait 4 hours before you
connect the appliance to the mains.
Before the initial operation
• Remove the protective sheets and all packaging
material incl. the transport securing of the stor-
age spaces and of the trays from the appliance.
• Dispose the packaging professionally.
• You might notice a slight 'new smell' when you
start the appliance for the first time. It goes away
once the appliance begins to cool.
• Clean the interior with tepid water with the
addition of washing-up liquid. Clean the equip-
ment separately with rinsing water, not in the
dishwasher.
• Before you fill the appliance with food, let it
work for 1 hour, so that the target temperature
can be reached. To make sure your goods are
fully frozen, wait 3 hours before taking them out
of the freezer.
Installation of the appliance
• The appliance should be installed in a dry and
well-aired room.
• The appliance can be operated at a humidity of
max. 70 %.
• The surrounding temperature, at which the
appliance can be operated, can be taken from
the appliance specification sheet at the end of
this manual.
• Do not install the appliance outdoors.
• Bear in mind that you can pull the power plug
anytime.
• Protect the appliance from direct insolation. It
should not be installed near heat sources (stove,
heater, etc.). If this, however, cannot be avoided,
you should put isolation between the heat source
and the appliance.
• You must not imbed the appliance in a cabinet.
The installation of the fridge directly under a
board or a cabinet is disallowed.
• The unevenness of the
floor can be compen-
sated with the two
vertically adjustable
screw-in feet in the
front, so that safe
stability is attained.
8930_31_32_33_34_35_multi.indd 17
Installation measures
If the appliance is placed sideways on a wall, you
will leave a lateral gap of at least 60 mm, so that
the doors of the appliance can open in a 90-degree
angle. In order to be able to remove the VeggiBox
completely from the appliance, detach the bottle
compartment if necessary.
Width (W)
Depth (D)
550 mm
A
B
903 mm 1100 mm
- 17 -
Height (H)
615 mm
1460 mm
C
E
F
125°
30 mm
100 mm
12.10.2018 12:03:31
Advertenties
Inhoudsopgave
