Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Installing hob
● Using an electrical cord, connect the hob according to electrical diagram provided.
● Remove dust from the worktop, insert hob into the opening and press in firmly.
Assembly of the gasket
*Depending on the model, the seal is already installed at the factory (fig.1)
If the seal has not been fitted at the factory, proceed as follows:
Before installing the hob in the cut-out worktop, the gasket is to be attached to the back
of the hob (pic. 2)
To do this, first peel off the protective film from the self-adhesive seal and glue the gasket
as close as possible to the outer edge of the hob (fig. 3,4).
Do not install the appliance without the
foam gasket.
Then turn the hob over insert it into the cut-out of the
furniture. Align the positioning symmetrically so that the
distances between the hob and the countertop is the
same on all sides. (fig. 5)
* some models come with the sealing glued to the board
1
2
1
3
2
72
1 - Worktop
2 - Hob flange gasket
3 - Ceramic hob
3
U S Z
5
4
C Z E
K L E
J
L K A
Advertenties
Inhoudsopgave
