Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Malfunction
The programme
does not start.
After the check, switch on the appliance.
The programme continues from the point of
interruption.
If the malfunction shows again, contact the
service centre.
For other fault codes, not showed in the
chart, contact the service centre.
The necessary data for the service centre is
on the rating plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
All manuals and user guides at all-guides.com
Fault code
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust-
ment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
Possible cause
The appliance door is
open.
The mains plug is not
connected in.
Blow out fuse in the
household fuse box.
The delay start is set.
(Only for appliances
with delay start).
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Make sure that the washing pro-
gramme is applicable for the
type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
electrolux 31
Possible solution
Close the door correctly.
Put in the mains plug.
Replace the fuse.
If you want to cancel
the delay start, refer to
'Select and start a
washing programme'.
....................
....................
....................
Possible solution
Advertenties
Hoofdstukken
Inhoudsopgave
