Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Switching on and power setting
Residual heat indicator
Boost
GB 16
1. Place a pan in the middle of a cooking zone.
2. Press the key button.
A single beep will be heard.
3. Press the on/off button of the cooking zone concerned.
In the display '-' will blink and you will hear a single signal. If no
cooking setting is selected after a zone is switched on, the cooking
zone switches off automatically after 10 seconds.
4. Slide with your finger over the slide control (clockwise) or tap with
your finger on the slide control to set the desired setting. The hob
starts automatically at the selected level.
5. Set a higher or lower power level by sliding with your finger over the
slide control or by tapping on the slide control. The cooking zones
have 12 levels. In addition there is also the 'boost' level for the
induction zones.
Pan detection
If the hob doesn't detect a(n) (iron-containing) pan after a cooking
power has been set, the display will continue to flash and the cooking
area remains cold. When no (iron-containing) pan is placed within one
minute, the cooking zone will switch off automatically (also refer to
pages 14 and 15; "Pans").
After a cooking zone has been used it may still remain hot for a while.
As long as the cooking zone is still hot an "H" will be visible in the
display.
You can use the 'boost' function to cook at the highest power level
during a short period of time (max.10 minutes). After the maximum
boost time the power will be reduced to setting 12.
Advertenties
Hoofdstukken
Inhoudsopgave
