Please pay attention to the information under System Options Remote
Options 1 Ring Answer" if there are other devices on the analog
telephone line used by the device.
Dial-in with function "1 Ring Answer" OFF
Dial into the device by dialing the device's telephone number.
1.
Note: The device accepts the call after the set number of rings
(see "Rings to Answer"). You will hear several beeps.
2.
Now enter your 4-digit remote access code (factory setting: 5678).
A confirmation signal sounds if the entered code is correct. You
are now in remote access mode. The options that are now
possible are described later in the Functions section.
Dial-in with function "1 Ring Answer" ON
1.
Dial into the device by entering the telephone number of the
device.
2.
Let it ring once or twice and then hang up.
3.
Wait about 10 seconds and then dial into the device again. The
device now accepts the call immediately after the first ring. You
will hear several beeps.
4.
Now enter your 4-digit remote access code (factory setting: 5678).
A confirmation signal sounds if the entered code is correct. You
are now in remote access mode. The options that are now
possible are described later in the Functions section.
13.4.2
Remote access through an alarm message
With this option, you take action after an alarm call from the device.
In this case, the called contact can start remote access mode after
confirmation of the message.
"Remote Access" must be turned ON. See "Menu Functions System
Options Remote Options".
Message confirmation and start of remote access mode
1.
Answer the telephone as normal when it rings.
2.
Listen to the message. The message is repeated several times.
3.
If you have understood the message, you have two options:
Press the 8 key on your telephone. The message is
confirmed as usual, and the call ends.
Press the star key (*) on your telephone. This confirms the
message, and remote access can be started.
60 UK